DNCv7 CNC Communications Software

Super easy to use DNC software. Completely rewritten to to meet Windows 10 64-bit design requirements (backwards compatible with Windows XP/Vista/7/8). Works with the RS232 interface of most CNC controls and similar devices. Is the best DNC software for use with Haas machine tools.

Supported Controls

  • Acramatic
  • Amada
  • Anilam
  • Boss
  • DynaPath
  • Fadal
  • Fagor
  • FANUC
  • Haas Automation
  • Heidenhain
  • Hitachi
  • Mazak
  • Mitsubishi
  • Okuma
  • Siemens SINUMERIK
  • Traub
  • Yasnac
  • Many other similar controls
  •  

Highlights and Features

  • Recommended by Haas Automation CNC dealers
  • Made and supported in USA since 1995 by former Haas Automation engineer
  • Sold and supported directly, no variations on multiple websites
  • Simple and easy to setup and use, point-and-shoot intuitive interface
  • Minimalist design, no extraneous settings or prompts to slow you down
  • Prompt to name file received at PC is deferred until after text of received file is displayed
  • Profile library saves settings for each CNC
  • Supports long file names and UNICODE
  • ClearType compatible and DPI aware for high resolution monitors, text is alway sharp and clear
  • Lightweight, runs fine on old PC hardware
  • Multithreaded
  • Does not require administrator rights to run
  • Compatible with Windows UAC and DEP
  • Does not attempt to store files or registry values in protected or virtualized locations
  • No DOS or 16-bit components used
  • No timeouts, lost characters, or lockups
  • No fixed limits on NC file size

File Transfer Functions

  • Drip-feed very large NC file to CNC while it is running, Xon/Xoff or XMODEM
  • Send/receive NC file to/from CNC memory, Xon/Xoff or XMODEM
  • Send/receive control settings, offsets, and parameters
  • Backup all NC files from control into single file
  • Haas machine data collection support available
  • Fadal checksum supported (PC to Fadal)
  • Capture DPRNT

Edit Functions

  • Find/replace text
  • Undo/redo (multilevel)
  • Strip N-numbers
  • Re-sequence N-numbers
  • Re-sequence every n-th block
  • Strip white space and non printable characters
  • Add inter-address spacing
  • Repair diagonal lines
  • Repair every other line blank

RS232 Communications Settings

  • Baud: 115200, 38400, 19200, 9600, 4800, 2400, 1200, 600
  • Serial Port: COM1 – COM99
  • Protocol: Xon/Xoff, XMODEM
  • Parity Bit: Even, None
  • Data Bits: 7, 8
  • Stop Bits: 1, 2

Advanced Send Settings

  • Wait for Xon: On, Off
  • Label Skip: On, Off
  • EOB Delay: 0, 16, 32, 64, 256 milliseconds
  • FIFO: 1, 2, 4, 8, 16 bytes
  • Strip CR: On, Off
  • Control Type: ISO/ASCII, HAAS, FANUC, FADAL

Contact

 

Sihler Engineering / dncsoftware.com

Camarillo California 93012

Office phone: (805) 419-0226

Email: support@dncsoftware.com

You Might Also Like
Leave a Reply